ACT-PS512K8 High Speed 4 Megabit Plastic Monolithic SRAM Plastic PathTM Features Vss Vcc 512Kx8 8 I/O0-7 Pin Description I/O0-7 Data I/O A0-18 Address Inputs WE Write Enable CE Chip Enable OE Output Enable VCC Power Supply VSS Ground NC Not Connected A E RO C F LE X LA ISO 9001 E I NC . CE WE OE A0 - A18 www.aeroflex.com S Block Diagram - SOJ (L2) CIRCUIT TECHNOLOGY B Low Power Monolithic CMOS 512K x 8 SRAM Operating Temperature Range Full Military (-55C to +125C) Industrial (-40C to +85C) Burn-in and Temperature Cycle Available 10, 12, 15, 17, 20 & 25ns Access Times +5V Power Supply Industry Standard Pinouts Center Power / Ground Pins TTL Compatible I/O 3.3V Device I/O Interfacing JEDEC Standard 36 pin Plastic SOJ Package 36 Lead, .93" x .405" x 0.148 Small Outline J lead (SOJ), Aeroflex code# "L2" Fully Static Operation No Clocks or Refresh Required RTIFIED General Description The ACT-PS512K8 is a Plastic High Speed, 4 Megabit (4,194,304 bits) CMOS Monolithic SRAM organized as 524,288 words by 8 bits. Designed for high-speed, high density, high reliablility, mass memory and fast cache system applications. The plastic monolithic is input and output TTL compatible. Writing is executed when the write enable (WE) and chip enable (CE) inputs are low. Reading is accomplished when WE is high and CE and output enable (OE) are both low. Access time grades of 10ns 12ns, 15ns, 17ns, 20ns and 25ns are standard. eroflex Circuit Technology - Advanced Multichip Modules (c) SCD3764 REV A 6/2/98 Absolute Maximum Ratings Symbol Parameter TC TSTG MINIMUM MAXIMUM Units Case Operating Temperature -55 +125 C Storage Temperature -65 +150 C 1.0 W PD Maximum Package Power Dissipation VG Maximum Signal Voltage to Ground -0.5 VCC + 0.5 V VCC Power Supply Voltage -0.5 +7.0 V Recommended Operating Conditions Symbol Parameter Minimum Maximum Units +4.5 +5.5 V 0 0 V VCC Power Supply Voltage VSS Ground VIH Input High Voltage +2.2 VCC + 0.5 V VIL Input Low Voltage -0.5 +0.8 V TC Operating Temperature (Military) -55 +125 C TC Operating Temperature (Industrial) -40 +85 C Truth Table Mode CE WE OE Data I/O Standby Output Disable Read Write H L L L X H H L X H L X High Z High Z Data OUT Data IN Supply Current ISB ICC ICC ICC Capacitance (VIN & VOUT = 0V, f = 1MHz, TC = 25C, unless otherwise noted, Guaranteed but not tested) Symbol CIN COUT Parameter Maximum Units Input Capacitance (A0-18, WE & OE) 6 pF Output Capacitance (I/O0-7 & CE) 8 pF DC Characteristics (VCC = 5.0V, VSS = 0V, TC = -55C to +125C or -40C to +85C) Parameter Sym Conditions Min Max Units Input Leakage Current ILI VCC = Max, VIN = VSS to VCC -10 +10 A Output Leakage Current ILO -10 +10 A Operating Supply Current ICC CE = VIH, OE = VIH, VOUT = VSS to VCC CE = VIL, OE = VIH,f =5MHz,Vcc=5.5V 130 mA Standby Current ISB CE = VIH, OE= VIH, f =5MHz,Vcc=5.5V 20 mA Output Low Voltage VOL IOL = 8 mA, Vcc = 4.5V 0.4 V Output High Voltage VOH IOH = -4 mA, Vcc = 4.5V 2.4 V Note: DC Test conditions: VIL = 0.3V, VIH = Vcc - 0.3V. Aeroflex Circuit Technology 2 SCD3764 REV A 6/2/98 Plainview NY (516) 694-6700 AC Characteristics (VCC = 5.0V, VSS= 0V, TC = -55C to +125C or -40C to +85C) Read Cycle Parameter Sym -010 -012 -015 -017 -020 -025 Min Max Min Max Min Max Min Max Min Max Min Max Units ns Read Cycle Time tRC Address Access Time tAA 10 12 15 17 20 25 ns Chip Enable Access Time tACE 10 12 15 17 20 25 ns Output Hold from Address Change tOH Output Enable to Output Valid tOE Chip Enable to Output in Low Z (1) tCLZ 3 3 3 3 3 3 ns Output Enable to Output in Low Z (1) tOLZ 0 0 0 0 0 0 ns Chip Deselect to Output in High Z (1) tCHZ 5 6 7 7 8 10 ns Output Disable to Output in High Z (1) tOHZ 5 6 7 7 8 10 ns 10 12 3 15 3 5 17 3 6 20 3 25 4 7 8 ns 5 10 ns 12 Note 1. Guaranteed by design, but not tested Write Cycle -010 -012 -015 -017 -020 -025 Min Max Min Max Min Max Min Max Min Max Min Max Parameter Sym Write Cycle Time tWC 10 12 15 17 20 25 ns Chip Enable to End of Write tCW 7 8 10 12 13 15 ns Address Valid to End of Write tAW 7 8 10 12 13 15 ns Data Valid to End of Write tDW 5 6 8 8 9 10 ns Write Pulse Width tWP 7 8 10 12 13 15 ns Address Setup Time tAS 0 0 0 0 0 0 ns Address Hold Time tAH 0 0 0 0 0 0 ns Output Active from End of Write (1) tOW 3 3 3 3 4 5 ns Write to Output in High Z (1) tWHZ tDH Data Hold from Write Time 5 6 0 0 7 0 8 0 8 0 Units 10 ns 0 ns Note 1. Guaranteed by design, but not tested Data Retention Electrical Characteristics (Special Order Only) VCC = 5.0V, VSS= 0V, TC = -55C to +125C or -40C to +85C) Parameter Sym Test Conditions VCC for Data Retention VDR CE VCC - 0.2V Data Retention Current ICCDR1 VCC = 3V Aeroflex Circuit Technology 3 Min All Speeds Typ 2 0.5 Max Units 5.5 V 2.0 mA SCD3764 REV A 6/2/98 Plainview NY (516) 694-6700 Timing Diagrams -- SRAM Write Cycle Timing Diagrams Read Cycle Timing Diagrams Write Cycle (SWE Controlled, OE = VIH) Read Cycle 1 (SCE = OE = VIL, SWE = VIH) tWC tRC A0-18 A0-18 tAA tAW tCW tOH DI/O Previous Data Valid tAH SCE Data Valid tAS tWP SWE tOW tWHZ tDW SEE NOTE D I/O tDH Data Valid Read Cycle 2 (SWE = VIH) tRC Write Cycle (SCE Controlled, OE = VIH ) A0-18 tWC tAA A0-18 tAH tAW SCE tACE tAS tCHZ tCLZ SEE NOTE SCE tOHZ SWE tCW SEE NOTE OE tWP tOE SEE NOTE tOLZ SEE NOTE DI/O tDW DI/O UNDEFINED tDH Data Valid High Z Data Valid Note: Guaranteed by design, but not tested. DON'T CARE AC Test Circuit Current Source AC Test Conditions IOL VZ ~ 1.5 V (Bipolar Supply) To Device Under Test C L = 50 pF Parameter Typical Units Input Pulse Level 0 - 3.0 V Input Rise and Fall 5 ns Input and Output Timing Reference Level 1.5 V IOH Current Source Notes: 1) VZ is programmable from -2V to +7V. 2) IOL and IOH programmable from 0 to 16 mA. 3) Tester Impedance ZO = 75. 4) VZ is typically the midpoint of VOH and VOL. 5) IOL and IOH are adjusted to simulate a typical resistance load circuit. 6) ATE Tester includes jig capacitance. Aeroflex Circuit Technology 4 SCD3764 REV A 6/2/98 Plainview NY (516) 694-6700 Pin Numbers & Functions 36 Pins -- SOJ Pin # Function Pin # Function 1 A0 19 NC 2 A1 20 A10 3 A2 21 A11 4 A3 22 A12 5 A4 23 A13 6 CE 24 A14 7 I/O0 25 I/O4 8 I/O1 26 I/O5 9 VCC 27 VCC 10 VSS 28 VSS 11 I/O2 29 I/O6 12 I/O3 30 I/O7 13 WE 31 OE 14 A5 32 A15 15 A6 33 A16 16 A7 34 A17 17 A8 35 A18 18 A9 36 NC Package Outline "L2" -- SOJ Package, 36 Leads 36 23.62 (.930) 23.37 (.920) 19 11.30 (.445) 11.05 (.435) 10.29 (.405) 10.03 (.395) 1 9.65 (.380) 9.14 (.360) 18 .69 MIN (.027) 3.76 (.148) MAX 0.95 (.037) 1.27 TYP (.050) .43 +.10 -.05 TYP (.017 +.004) -.002) .004 MAX All dimensions in inches Dimensions in millmeters mm Dimensions in inches (.xxx) Aeroflex Circuit Technology 5 SCD3764 REV A 6/2/98 Plainview NY (516) 694-6700 CIRCUIT TECHNOLOGY Ordering Information (Typical) Model Number Options Speed Package ACT-PS512K8N-010L2I None 10ns 36 Lead SOJ ACT-PS512K8W-012L2I Burn-in 12ns 36 Lead SOJ ACT-PS512K8X-015L2T Temp Cycle 15ns 36 Lead SOJ ACT-PS512K8Y-017L2T Temp Cycle & Burn-in 17ns 36 Lead SOJ ACT-PS512K8Y-020L2T Temp Cycle & Burn-in 20ns 36 Lead SOJ ACT-PS512K8Y-025L2T Temp Cycle & Burn-in 25ns 36 Lead SOJ Part Number Breakdown \\\ Aeroflex Circuit Technology ACT- P S 512K 8 N- 010 L2 T Plastic Path Electrical Testing I = Industrial Temp, -40C to +85C T = Military Temp, -55C to +125C Memory Type S = Plastic SRAM Memory Depth, Locations Memory Width, Bits Package Type & Size Options N = None W = Burn-in * X = Temperature Cycle * Y = Burn-in & Temperature Cycle L2 = 36 Pin Plastic SOJ * Screened to the test methods of MIL-STD-883 * Memory Speed, ns 010 = 10ns 012 = 12ns 015 = 15ns 017 = 17ns 020 = 20ns 025 = 25ns Telephone: (516) 694-6700 FAX: (516) 694-6715 Toll Free Inquiries: 1-(800) 843-1553 Aeroflex Circuit Technology 35 South Service Road Plainview New York 11830 Aeroflex Circuit Technology 6 SCD3764 REV A 6/2/98 Plainview NY (516) 694-6700