CrystalFreeTM Solid-State Oscillator 3CN Ultra Low Power Oscillators PRELIMINARY DATA SHEET Features Frequency Range: Output Type: Frequency Tolerance: Supply Voltage: Power Consumption: Standby Current: Standard Package: Operating Temperature: 4 to 133 MHz CMOS 100 ppm 1.8 to 3.3 V 1.9 mA (1.8 V) < 1 uA 5.0 x 3.2 x 0.85 mm 2.5 x 2.0 x 0.85 mm 0 to 70 C, -20 to 70 C This product is rated "Green", please contact factory for environmental compliancy information Specification Symbol Specifications VDD 1.8 V 5% 2.5 V10% 3.3 V10% FSTB 100 ppm IDD 1.9 mA 2.0 mA 2.2 mA ISTBY 1 uA VIL/VIH 0.3 VDD (max) /0.7 VDD (min) VOL 0.1 VDD (max) / 0.9 VDD (min) TR /TF 1.6 ns 1.2 ns 1.0 ns 45% / 55% SYM Symmetry 40% / 60% Start-up time TST 400 us (max) Period Jitter RMS PJRMS 17 ps 6 ps 5 ps Cycle to Cycle Jitter(Pk-Pk) CCJPP 120 ps 50 ps 40 ps Parameter Supply Voltage Frequency Stability Supply Current Quiescent Current Input LOW/HIGH level Output LOW/HIGH level Rise/Fall Time Output Frequency Conditions Nominal tolerance Total Frequency Stability* Typical; No load condition; 75 MHz Maximum; STBY# = GND At STBY# pin IOL = - 1 mA / IOH = 1 mA Maximum; 20% to 80% x VDD; Output load (CL) = 4 pF Worst case; output frequencies 100 MHz Worst case; output frequencies > 100 MHz Output valid time after VDD meets the specified range & STBY# transition Output load (CL) = 4 pF; 75 MHz; measured over 10K cycles Output load (CL) = 4 pF; 75 MHz; measured over 1K cycles 4 4.096 5 6 15 16 18.432 19.44 36 37.5 40 48 75 80 98.304 100 Contact IDT for additional frequencies FOUT 6.144 20 49.152 125 7.3728 22.5972 50 133 8 24 60 10 24.576 62.5 12 25 66 12.5 30 66.66 12.288 33 72 14.31818 33.333 74.25 Note: Above specifications are typical at room temperature (25C ) unless otherwise specified. * Inclusive of initial frequency accuracy, operating temperature range, supply variation, load variation, 3 times solder reflow, shock, vibration and 10 years aging at 25C. Package Outline and Dimensions Typical PCB Land Pattern Pin #1 ID Chamfer 0.5 x 45 1.00 0.05 3.20 0.1 0.85 1.20 0.05 5.0 xx 3.2 5.0 3.2 2.2 0.0-0.05 STBY# 4L SMD 5.00 0.1 2.54 bsc 5.0 x 3.2mm Top View 0.65 0.05 Pin #1 ID Chamfer 0.35 x 45 Side View 1.4 1.5 0.0-0.05 0.85 0.05 STBY# 4L SMD 2.5 x 2.0mm 2.5 0.05 1.35 Bsc 1.62 Bsc VDD 0.20 REF 1.8 (mm) 0.72 0.05 OUT 0.20 Ref. Bottom View 2.0 0.05 1.6 GND 0.15 2.5 x 2.0 VDD 2.5 (mm) (mm) 0.85 0.05 OUT 0.9 GND 0.5 Top View Mar 26, 2012 Bottom View www.IDT.com Side View 0.8 (c)2011 Integrated Device Technology, Inc 3CN Datasheet CrystalFreeTM Solid-State Oscillator Solder Reflow Profile 1 2 3 4 100 60-150 sec 60-180 sec 50 Time Output Waveform Pin Descriptions Pin # 150C 150 cm ax 4.6 V -0.5 V to VDD + 0.5 V -0.5 V to VDD + 0.5 V -65C to 150C 217C 200 3 C/ se VDD STBY# OUT Storage Temperature (260C max) max Maximum Absolute Rating 250 /sec Item 40 sec (max) 245C 6C Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These ratings are stress specifications only. Functional operation of product at these or under any condition beyond those listed in the operating specifications is not implied. Exposure to absolute maximum rated conditions may affect product reliability. Temperature (C) Absolute Maximum Ratings Name Description STBY# GND OUT2 VDD 1 TR TF VOH Standby Mode (0 = Output Disabled) Ground CMOS Output Power 0.8 VDD 0.5 VDD 1. Pulled high internally 2. Weak pull down to GND during STBY# enable and startup 0.2 VDD VOL SYM = t1 / t2 t1 t2 Ordering Information 3CN11G 4.09600 22.5792 133.000 E NSG Package 8 Suffix NSG Frequency 4 to 133MHz* Package NSG: 5.0 x 3.2 x 0.85 CVG: 2.5 x 2.0 x 0.85 C: E: Temp 0 to 70C -20 to 70C Shipping CVG Blank: Tubes 8: Tape and Reel Minimum Order Quantity (MOQ) T&R Bulk Factory Order Increment (FOI) T&R Bulk 2500 1260 (18 Tubes) 2500 1260 (18 Tubes) 3000 1250 (Canister) 3000 1250 (Canister) * See frequency table or contact IDT 6024 Silver Creek Valley Road San Jose, California 95138 Sales 800-345-7015 (inside USA) +1 408-284-8200 (outside USA) Fax: 408-284-2775 Technical Support crystalfreetechsupport@idt.com +1 408-360-5656 DISCLAIMER Integrated Device Technology, Inc. (IDT) and its subsidiaries reserve the right to modify the products and/or specifications described herein at any time and at IDT's sole discretion. All information in this document, including descriptions of product features and performance, is subject to change without notice. Performance specifications and the operating parameters of the described products are determined in the independent state and are not guaranteed to perform the same way when installed in customer products. The information contained herein is provided without representation or warranty of any kind, whether express or implied, including, but not limited to, the suitability of IDT's products for any particular purpose, an implied warranty of merchantability, or non-infringement of the intellectual property rights of others. This document is presented only as a guide and does not convey any license under intellectual property rights of IDT or any third parties. IDT's products are not intended for use in life support systems or similar devices where the failure or malfunction of an IDT product can be reasonably expected to significantly affect the health or safety of users. Anyone using an IDT product in such a manner does so at their own risk, absent an express, written agreement by IDT. Integrated Device Technology, IDT and the IDT logo are registered trademarks of IDT. Other trademarks and service marks used herein, including protected names, logos and designs, are the property of IDT or their respective third party owners. Copyright 2010, 2011. All rights reserved. Mar 26, 2012 www.IDT.com (c)2012 Integrated Device Technology, Inc