VN340SP13TR - STMicroelectronics, Inc.

A ugust 2000 1/9

VN340SP

QUAD HIGH SIDE SMART

PO WE R SOL ID S TAT E R ELAY

OUTPUT CURRENT : 0.7A PER CHANNEL

DIGITAL I/O’s CLAMPED AT 32V MINIMUM

VOLTAGE

SHORTED LOAD AND OVERTEMPERATURE

PROTECTIONS

PROTECTION AGAINST LOSS OF GROUND

BUILT-IN CURRENT LIMITER

UNDERVO LTAGE SHUT-DOWN

OPEN DRAIN DIAGNOSTIC OUTPUT

FAST DEMAGNETIZA TI ON OF INDUCTIV E

LOADS

CONFORMS TO IEC 1131-2

DESCRIPTION

The V N340SP i s a mono lithic device made using

STMicroelectronics VIPower technology, intended

for driving four indipendent resistive or inductive

loads with one side connected to ground. Active

current limitation avoids dropping the system

power supply in case of shorted load. Built-in

thermal shut-down protects the chip from

overtemperature and short circuit. The open drain

diagnostic output indicates overtemperature

conditions. Each I/O is pulled down when

overtemperature condition of the relative channel

is verified.

TYPE Vdemag(*) RDSon (*) Iout (*) Vcc

VN340SP Vcc-55V 0.2Ω 0.7A 36 V

BLOCK DIAGRAM

(*) Per channel

PowerSO-10TM

Obsolete Product(s) - Obsolete Product(s)

2/9

VN340SP

ABSOLUTE MAXIMU M RAT ING

Symbol Parameter Value Unit

VCC Power supply voltage 45 V

-VCC Reverse supply voltage -4 V

IOUT Output current (continuous) Internally limited A

IRReverse output current (per channel) -6 A

IIN I np ut curr ent (per ch anne l) ± 10 m A

IDIAG Diag pin cur rent ±10 mA

VESD Electrostatic discharge (R=1.5KΩ; C=100pF) 2000 V

EAS Single pul se av alanche energy per c hannel n ot simultaneously

(see figure 1) 400 mJ

Ptot Power dissipation at Tc=25°C Internally limited W

TjJunction operating temperature Internally limited °C

Tstg Stor age tem perature -55 to 150 °C

CURRENT AND VOLTAGE CO NVENT IONS

CONNECTION DIAGRAM TO P VIEW

Obsolete Product(s) - Obsolete Product(s)

3/9

VN340SP

THERMAL D AT A

(*) see test configuration and application description

SWITCHI NG (VCC=24V)

Symbol Parameter Value Unit

Rthj-case Thermal resistance juncti on-case (1) (M AX) 3 °C/W

Rthj-amb Thermal resistance junction-ambient ($) (MAX) 50 °C/W

S ymbol Parameter Test Conditions M in Typ M ax Un it

VCC Supply voltage 10 36 V

RON On st ate resist ance IOUT=0.5A; Tj=25°C

IOUT=0.5A; -25°C<Tj<85°C

IOUT=0.5A; Tj=125°C

0.2

0.32

0.4

Ω

ISSupply current All channels off

On state; VIN=30V; IOUTn=0V

(Tj=125°C)

VOL Low state output voltage VIN=VIL; RLOAD>10MΩ1.5 V

Vdemag Output voltage at turn-off IOUT=0.5A; LLOAD=1mH VCC-65 VCC-55 VCC-45 V

ILGND Output current at turn-off VCC=VINn=VGND=VSTAT=18 t o 30 V

Tamb=-25°C to 85°C (*) 2mA

S ymbol Parameter Test Conditions Min Typ Ma x Unit

td(on) Tur n-on delay time of

Output current IOUT=0.5A, Resis tive Lo ad

Input rise time <0.1µs, T j=25°C 52 100 µs

trRise time of

Output current IOUT=0.5A, Resis tive Lo ad

Input rise time <0.1µs, T j=25°C 94 250 µs

td(off) Turn-off delay time of

Output current IOUT=0.5A, Resis tive Lo ad

Input rise time <0.1µs, T j=25°C 34 50 µs

tfFa ll time of

Output current IOUT=0.5A, Resis tive Lo ad

Input rise time <0.1µs, T j=25°C 820µs

POWER

ELECTRICAL CHARACTERI STICS (10V<VCC<36V;-25°C<Tj<85°C; unless otherwise specified)

(1) Per channel

($) When mounted using minimum recommended pad size on FR-4 board

Obsolete Product(s) - Obsolete Product(s)

4/9

VN340SP

ELECTRICAL CHARACTERISTICS (continued)

LOGIC INPUT (Per each channel)

Note 1 : The inp ut volt age is internall y cl am ped at 32V m inimum , it is pos s ible t o c onnect the input pins to an higher v oltag e via an externa l

resistor calculate to not exceed 10 m A .

PROTECTION AND DIAGNOSTI CS

(*) Status d etermination > 100µs after the swit c hing edge.

Note: If INPUT pin is floating the corrisponding channel will automatically switch off. If GND pin is disconnected, the channel will switch off

provided VCC not ex c eed 36V.

S ymbol Parameter Test Conditions M in Typ M ax Un it

VIL I/O Input low level volta ge 2 V

VIH

I/O Input high level

voltage

(see n ote 1) 3.5 V

VI(HYST) I/O Input hysteresis

voltage 0.5 V

IIN I/O Input current VIN=30V 25 µA

VICL I/O I nput clamp voltage

(see n ote 1) IIN=1mA

IIN=-1mA 32 36

-0.7 V

Symbol Parameter Test Conditions Min Typ Max Unit

VDI A G (* ) Status voltage output low ISTAT=5mA

(Fault condition) 1V

SCL(*) Status clamp voltage IDIAG=1mA

IDIAG=-1mA 32 36

-0.7 V

VUSD Undervolta ge shut down 5 8 V

ILIM DC Short circuit current VCC=24V ; R LOAD<10mΩ0.7 2 A

IOVPK Peak short circuit current VCC=24V ; V IN=30V; RLOAD<10mΩ

(see figure 2) 4A

DIAGH Leakage o n diag pin in

high state VDIAG=24V 25 µA

ILOAD Output leakage current VCC=10 to 36V; VIN=VIL 50 µA

tSC Delay time of current

limiter 100 µs

TTSD Thermal shut down

temperature 150 170 °C

TRThermal reset

temperature 135 155 °C

Obsolete Product(s) - Obsolete Product(s)

5/9

VN340SP

FIGURE 1: Avalanche Energy Test Circuit

FIGURE 2: Peak Short Circuit Current Test Circuit

Obsolete Product(s) - Obsolete Product(s)

6/9

VN340SP

Figure 3: Switching Waveforms

MCOUTn I/On OUTPUTn DIAGNOSTIC

N ormal operation L

Overtemperature L

Undervoltage L

Shorted load

(Current limi tatio n) L

THRUTH TABLE

Obsolete Product(s) - Obsolete Product(s)

7/9

VN340SP

VCC

DIAG

I/On

GND

OUTn

Ignd

FC12550

Fig. 4: ILGND Test Configuration

SWITCHING PARAMETERS T EST CONDITIONS

DRIVING CIRCUIT

Obsolete Product(s) - Obsolete Product(s)

8/9

VN340SP

DIM. mm. inch

MIN. TYP MAX. MIN. TYP. MAX.

A 3.35 3.65 0.132 0.144

A (*) 3.4 3.6 0.134 0.142

A1 0.00 0.10 0.000 0.004

B 0.40 0.60 0.016 0.024

B (*) 0.37 0.53 0.014 0.021

C 0.35 0.55 0.013 0.022

C (*) 0.23 0.32 0.009 0.0126

D 9.40 9.60 0.370 0.378

D1 7.40 7.60 0.291 0.300

E 9.30 9.50 0.366 0.374

E2 7.20 7.60 0.283 300

E2 (*) 7.30 7.50 0.287 0.295

E4 5.90 6.10 0.232 0.240

E4 (*) 5.90 6.30 0.232 0.248

e 1.27 0.050

F 1.25 1.35 0.049 0.053

F (*) 1.20 1.40 0.047 0.055

H 13.80 14.40 0.543 0.567

H (*) 13.85 14.35 0.545 0.565

h 0.50 0.002

L 1.20 1.80 0.047 0.070

L (*) 0.80 1.10 0.031 0.043

α0º 8º 0º 8º

α (*) 2º 8º 2º 8º

PowerSO-10™ MECHANICAL DAT A

(*) Muar only POA P013 P

DETAIL "A"

PLANE

SEATING

= =

0.10 A

DETAIL "A"

SEATING

PLANE

0.25

P095A

Obsolete Product(s) - Obsolete Product(s)

9/9

VN340SP

Informat ion furnished is believed t o be acc ur ate and r eliable. However, S TMicr oelect r onics assumes no res ponsibil ity for t he co nsequences

of use of such inf ormation nor for any infringement of patents or other rights of third parties which may results from its use. No license is

gran ted by implication or o therwise under any pate nt or pat ent rights of STMicroelectroni c s . Specifications mentio ned in this publication are

subj ec t to c hange without notice. This publ ic atio n s upers edes and replaces all inf or m ati on prev iously s upplied . STMicroelect r on ics pr oducts

are not au thorized for use as critical co mponents in life support devices or systems without express written ap proval of STMicroelectronics.

The ST log o is a trademark o f STMicroelectronics

 2 000 STM ic r oelectronics - P r inted in ITALY- All Rig hts Reserv ed.

STMicroelectronics GROUP OF C OMPANIES

Australia - Brazil - China - Finland - France - Germany - Hong Kong - India - Ita ly - Japan - Malaysia - Malta - Morocco -

Si ngapore - Spa in - S weden - Switzerland - United K ingdom - U.S.A.

http://www.st.com