WHITE-RODGERS DC PRODUCTS Type 586 sealed solenoid FEATURES * * * * Water resistant Double-make or double-break contacts Capable of handling high and low current requirements Black impact phenolic casing ENGINEERING DATA GENERAL DATA Contacts * Pole form-SPNO and SPDT * Material-silver alloy * Termination- 5/16"-24 UNF-2A thread RATINGS NO Volts DC 6 12 24 & 36 Cont. 200A 200 A 200 A NC Inrush 600 A 600 A 600 A Cont. 100A 100 A 100 A Inrush 300 A 300 A 200 A Coils * Voltage-6 VDC through 48 VDC * Termination-#10-32 UNF-2A thread * Power (approximate) Continuous 12 watts SPDT, 8 watts SPNO * Connections Coil isolated (two terminals) * Operate (77F/25C) 67% of nominal coil voltage (intermittent) 110% max. safe of nominal coil voltage Volts DC 6 12 15 18 24 36 48 COIL DATA Resistance in Ohms Intermittent Continuous SPDT SPNO SPDT SPNO 2.2 3.3 3.3 5.25 8.4 13.2 13.2 21.0 13.1 21.0 21.0 32.8 18.4 30.0 30.0 47.0 33.6 53.0 53.0 84.0 75.6 120.0 120.0 189.0 134.0 213.0 213.0 336.0 Dielectric Strength * 500 Volts Temperature Range * -40F/-40C to 149F/65C Mechanical Life (no load) * 100,000 cycles Electrical Life (rated load--making and breaking 200 amp on NO Contacts) * 50,000 cycles Mounting Position * Recommended mounting is vertical plane with coil terminals up Weight (approximate) * SPNO-24.0 oz. * SPDT-26.0 oz. Duty Cycle * Continuous * Intermittent--10 seconds "on" maximum and minimum 60 seconds "off" One minute "on" maximum and minimum 6 minutes "off" Hardware Torque Specification * Contact Terminal: 60 inch-lbs. max. * Coil Terminal: 12-18 inch-lbs. max. Intermittent--special request only St. Louis, Missouri Markham, Ontario 314-553-3600 905-948-3411 www.white-rodgers.com The Emerson logo is a trademark and a service mark of Emerson Electric Co. R-4005B 1232 TYPE 586 PART NUMBERING SYSTEM 586 - x xx x x x - x Basic Part Number Series Coil Voltage/Duty 02 - 6 Volt continuous 05 - 12 Volt continuous 08 - 15 Volt continuous 14 - 24 Volt continuous 16 - 28 Volt continuous 17 - 36 Volt continuous 20 - 48 Volt continuous Contact Form 1 - SPNO 3 - SPDT Mounting Bracket 1 - Standard bracket Coil Termination 1 - Isolated Factory Assigned Specials Contact Material (where undefined, contact factory) 1 - AgCdO APPLICATION NOTES * Not all part number combinations are available. Please contact your Sales Representative for available part numbers. * Solenoids applied in battery charging circuits should be protected from higher than rated voltage during charging. The service life may be affected by this condition and the solenoid may or may not operate the circuit as intended. * Circuits should be designed to provide safe operation should the solenoid fail in either the open or closed position. No dash - Standard assembly, hardware sent bulk 2 - Customer requested markings 3 - Customer requested markings 3A - Customer requested markings 5 - Customer requested markings 6 - Customer requested markings 6A - Customer requested markings 7 - Customer requested markings SPDT - Isolated Coil .281 WIDE X .640 LONG SLOT NORMALLY .594 OPEN #10-32 UNF-2A X .375 LONG W 3.300 NORMALLY CLOSED 1.156 H 2.797 2.300 1.274 5/16-24 UNF-2A X .594 LONG CIRCUIT DIAGRAM L 4.618 1.375 SPNO - Isolated Coil .281 WIDE X .640 LONG SLOT NORMALLY .594 OPEN #10-32 UNF-2A X .375 LONG W 3.300 1.156 H 2.797 2.300 1.274 CIRCUIT DIAGRAM 5/16-24 UNF-2A X .594 LONG L 3.688 1.375 R-4005C 1232 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: White-Rodgers: 586 317111