Features DALI Converter Compliant with DALI Standard (IEC62386 Part 102 & Part 206) Screw-less Connectors, Easy to Install Selectable Output for DC 0-10V / DC 1-10 / PWM Built-in Relay to Turn ON/OFF Driver Completely (Zero Standby Current) Over Voltage and Short Circuit Protection LIGHTLINE DALI-Converter AC/DC with 5 year Warranty Description The RELI-DA01/R is a DALI to analog control signal interface which is compliant with the DALI IEC62386 standard and listed on the agDALI website.. The output is selectable between 0-10V and 1-10V or PWM (1) and is compatible with all RECOM dimmable LED drivers as well as other manufacturer's products. The output can control several LED drivers, allowing the lighting in a whole room or office to be dimmed with just one DALI address. A built-in relay can be used to switch off the LED drivers under software control to give zero no-load consumption. The interface is universal AC powered (110VAC, 230VAC or 277VAC). 1.6 Watt DALIConverter Selection Guide Part Number Input Voltage (VAC) Power Consumption (W) DALI Bus Power Consumption (mA) DALI Standard IEC62386 Dimming Output RELI-DA01/R 90-290 1.6 typ. 2 max. Part-102 DC 0-10V Part-206 DC 1-10V or PWM (1) Specifications (measured at TA = 25C and nominal input voltage) Input Voltage Range 90-290VAC, 50/60Hz Power Consumption 1.6W typ. / 3W max. DALI Bus Current Consumption 2mA max. Suitable Electric Wire IEC 62386-102 Compliant IEC 62386-206 Compliant EN55015 Certified EN61347 Certified EN61547 Certified 22 AWG - 16 AWG PWM Frequency 500Hz typ. PWM High Level Voltage 9.5VDC min. / 10VDC typ. / 10.5VDC max. PWM Low Level Voltage 0VDC typ. PWM Output Current Sourcing (mA) RELI-DA01/R -60mA min. / 60mA max. 3% DC 0/1-10V Output Accuracy DC Output Current Sourcing (mA) -5mA min. / 60mA max. DALI Standard IEC62386 Part-102 & Part-206 Short Circuit Protection (Dimming Output) Over Voltage Protection (DALI connector) Operating Temperature Range Ambient Temperature (free air convenction) Case Temperature Relay Switch cont., current limited to 240mA 24V Zener Diode clamp -20 to +40C 46C 1 Channel, 2A cont. / 70A inrush handling IP Rating IP20 Dimensions 150 x 40 x 28mm Weight Safety Standards (100-240VAC) RoHS 2011/65/EU 6/6 Note1: PWM output is not included in the IEC62386 standard 100g 10% Report: P201311017 EN61347-1, 2nd Edition EN61347-2-11, 1st Edition EMC Emmission Report: HA140050 IEC61000-3-2, 3 EN55015 EMC Immunity IEC61000-4-2,3,4,5,6, 8, 11; Class A EN61547 MTBF (+25C) using MIL-HDBK 217F 200 x 10 hours min. Refer to Application Notes L-72 REV: 0/2015 www.recom-power.com RELI-DA01/R Series LIGHTLINE AC/DC-Converter Typical Characteristics DALI Declaration for Factory Variables (for Part 102) Variable Actual Dim Level Power on Level System Failure Level Min Level Max Level Fade Rate Fade Time Short Address Search Address Random Address Group 0-7 Group 8-15 Group 0-15 Status Information Version Number x = actual value depend on the operation status Default Value 254 254 254 Physical Min Level 254 7 (45 steps/s) 0 (no fade) 255 (Mask) Reset Value 254 254 254 Physical Min Level 254 7 (45 steps/s) 0 (no fade) no change FF FF FF FF FF FF 0000 0000 (no group) 0000 0000 (no group) 255 (Mask) 1xx0 xxxx 1 FF FF FF FF FF FF 0000 0000 (no group) 0000 0000 (no group) 255 (Mask) 0x10 0xxx no change Range of Validity 0, Min Level - Max Level 0 - 255 (Mask) 0 - 255 (Mask) Physical Min Level - Max Level Min Level - 254 1-15 0-15 0-63 255 (Mask) 00 00 00 - FF FF FF 00 00 00 - FF FF FF 0 - 255 0 - 255 0 - 255 (Mask) 0 - 255 Factory-defined DALI Declaration for Factory Variables (for Part 206) Reset Value No change No change No change No change No change No change No change Received Command 0 0011 a101 0000 0000 0000 0000 1 5 1 Range of Validity 0-1; (2 - 255 reserved) 53; 61 0 - 255 0 - 255 Factory-defined Factory-defined 1-253 DALI Command Set The RELI-DA01/R has been accepted by agDALI as conforming to the DALI standard for Control Gear (IEC 62386-102) and Device Type 5 (IEC 62386-206). It supports all relevant commands of the defined command set. Command Number 0 1 2 5 6 Command Name DIRECT ARC POWER OFF UP DOWN RECALL MAX RECALL MIN Function set directly the light level switch off the light dim up the light dim down the light recall the maximum light level recall the minimum light level Not supported commands include the "QUERY LAMP FAILURE" and the "QUERY LAMP POWER ON". Additionally the features to disable the Relay Switch, set the output to PWM, change the PWM from activehigh to active-low are additional and not tested by DALI (refer to the RELI-DA01/R instruction manual). www.recom-power.com REV: 0/2015 L-73 RELI-DA01/R Variable Default Value Dimming Curve 0 Converter Features 0011 a101 Failure Status 0000 0000 Converter Status 0000 0000 Extended Version Number 1 Device Type 5 Physical min Level 1 a = 0 Relay Function dissabled; a = 1 Relay Function enabled RELI-DA01/R Series LIGHTLINE AC/DC-Converter Recommended LED Drivers, DALI-Bus Power Supplies and DALI Master AC/DC LED Driver DC/DC LED Driver RACD20-xxxD RACD60-xxxxA RACD45-xxxxA RACD100-xxxxA RACD150-xxxxA RCD24-xxx RCD48-xxx RBD12-xxx DALI Master custom commands tested with DALI-USB Tridonic Osram (IEC62386 compatibility confirmed by DIAL ag using Prohibit Tester) *Software masterCONFIGURATOR V2.6.8.1005 Tridonic Note: For one DALI Converter (RELI-DA01/R) up to 6pcs of RECOM AC/DC LED-Drivers with 3in1 dimming can be connected. Typical Characteristics Default-Setting Log. 1-10V Dimming 10 Output Voltage [V] DALI-COMMAND Logarithmic Dimming; 1-10V 6 Recall MIN Level 257 DATA TRANSFER REGISTER (DTR) / Value: 0 dec 272 ENABLE DEVICE TYPE X / Value: 5 dec 224 QUERY APP EXT Cmd224 224 QUERY APP EXT Cmd224 272 ENABLE DEVICE TYPE X / Value: 5 dec 229 QUERY APP EXT Cmd229 229 QUERY APP EXT Cmd229 1 0 50 100 150 200 250 Internal switch: OFF Dimming Digits [1-254] DALI bus DALI Connection 230VAC 50Hz 1/N/PE A1 A2 RELI-DA01/R A B brown blue brown blue L VAC in N VAC in L VAC in DALI NAC L AC L-74 + black DALI SUPPLY - white OUTPUT L1 N PE A3 RACD60-2500A IP67 version DA DA + - +Vout -Vout -Dim +Dim 10V PWM or DC 0/1-10V red black white blue An N VAC in REV: 0/2015 -Dim +Dim www.recom-power.com RELI-DA01/R Series LIGHTLINE AC/DC-Converter ON Package Style Indicator LED flashes with DALI signal ON ON / OFF PWM / DC By internal switch ON: PWM 10V (Default active high) OFF: DC 1-10V (Default DC) DC 0-10V (software control) Delivery setting: Output signal: DC 1-10V Dimming curve: Logarithmic PWM active high Refer to instruction sheet for DALI commands for alternate settings (linear dimming curve, DC 0-10V, PWM active low, Independent Relay control) RELI-DA01/R Dimensions tc 65 20 4 40 130 28 150 The product information and specifications are subject to change without prior notice. RECOM products are not authorized for use in safety-critical applications (such as life support) without RECOM's explicit written consent. A safety-critical application is defined as an application where a failure of a RECOM product may reasonably be expected to endanger or cause loss of life, inflict bodily harm or damage property. The buyer shall indemnify and hold harmless RECOM, its affiliated companies and its representatives against any damage claims in connection with the unauthorized use of RECOM products in such safety-critical applications. www.recom-power.com REV: 0/2015 L-75