DATA SHEET HY2001 30 WATTS The ILP HY2001 Power Amplifier is a fully encapsulated high quality power amplifier with Integral Power Supply and heatsink. By selecting the appropiate mains transformer and the programming link on the PCB the amplifier can be used with 4 or 8 loads with the automatic adjustment of input sensitivity. Mounting can be achieved by the use of T-slots in the heatsink and the nuts and bolts provided. TYPICAL SPECIFICATIONS Parameter Output Power Frequency Response (-3dB) Total Harmonic Distortion @ 1kHz Signal to Noise Ratio (DIN AUDIO) Slew Rate typical Rise Time Input Sensitivity Input Impedance Damping Factor(8 @ 100Hz) Load Impedance (programmable) Maximum D.C. rails (8 load) Size Width x Height x Extrusion Cut Weight Value 40W rms. Max 15Hz - 50kHz 0.005% 100dB 10V/S 5S 500mV rms. 100K >400 4 or 8 30V 76x100x30mm 200g POWER SUPPLY REQUIREMENTS * FEATURES * Programmable 4 or 8 operation * Integral Power Supply * Anti-thump Circuitry * Integral heatsink * Thermal Protection * PTH Circuit Board * Encapsulated ILP have developed a range of Hi-Fi quality Low noise Audio Power Toroidal Transformers for the HY2001 they are Low Profile with Resin filled centres for maximum noise absorption and ease of mounting. Finished in black to match the amplifiers these transformers are the ideal choice to power the HY2001. Mode 4 8 Transformer AT0304 AT0308 RMS Supply Voltage 16 - 0 - 16v 20 - 0 - 20v Size 90x34mm 90x34mm SPONG LANE ELMSTED ASHFORD KENT TN25 5JU PHONE +44 (0)1233 750481 FAX +44 (0)1233 750578 Weight 0.9Kg 0.9Kg ELECTRICAL / MECHANICAL DETAILS AND DIMENSIONS INSTALLATION NOTES 1. 2. 3. 4. For normal usage and conditions the amplifier needs no supplementary heatsink. It must be mounted to allow a vertical flow of air through the fins. No input capacitor is required. An internal 100V working capacitor is fitted. For loudspeaker protection it is recommended that a quickblow fuse is mounted between the output and the speaker. The fuse rating specified has been calculated to ensure fast rupture in the event of DC being presented to the speaker. It is advised not to use a higher rated fuse. 5. The amplifier module is supplied in 8 mode. To set 4 mode simply break the link using a spot face cutter or a 3-5mm drill. 6. For 4 mode use a 2.0A quickblow fuse and for 8 a 1.5A quickblow fuse.