DESCRIPTION
Document No. VAL UERAM1586-001.A00 09/29/16 Page 1
SPECIFICATIONS
Continued >>
kingston.com
FEATURES
ValueRAM's KVR16LE11/8 is a 1G x 72-bit (8GB) DDR3L-1600
CL11 SDRAM (Synchronous DRAM) 2Rx8, ECC, low voltage,
memory module, based on eighteen 512M x 8-bit FBGA
components. The SPD is programmed to JEDEC standard
latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V. This
240-pin DIMM uses gold contact fingers. The electrical and
mechanical specifications are as follows:
• JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~
1.575V) Power Supply
• VDDQ = 1.35V (1.28V ~ 1.45V and 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal banks
• Programmable CAS latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write (either on the fly using A12 or
MRS)
• Bi-directional Differential Data Strobe
• Internal (self) calibration: Internal self calibration through ZQ
pin (RZQ: 240 ohm ± 1%)
• On Die Termination using ODT pin
• On-DIMM thermal sensor (Grade B)
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°Cº
• Asynchronous Reset
• PCB: Height 1.180” (30.00mm), double sided component
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command T ime (tRFCmin)
Row Active T ime (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
11 cycles
48.125ns(min.)
260ns(min.)
35ns(min.)
TBD W
94 V - 0
0o C to +85o C
-55o C to +100o C
Memory Module Specifi cations
KVR16LE11/8HD
8GB 2Rx8 1G x 72-Bit PC3L-12800
CL11 240-Pin ECC DIMM
SDRAM SUPPORTED
Hynix D-Die
Document No. VALUERAM1586-001.A00 Page 2
MODULE DIMENSIONS
kingston.com
