ane CTs. Series HVC Commercial 2 diameter, 2 watt high voltage composition variable resistor e High voltage rating e Reliable CTS composition resistance element e Wide resistance range e 2 watt rating e Selection of shafts and bushings Electrical and Mechanical Specifications Resistance Range 5K ohms to 50 megohms (linear taper) Resistance Tolerance Standard +30% Special Available in most resistance values at extra cost. Power Rating, Watts 2 watts @ 40C, derated to no load @ 100C. Voitage Rating Bushing to Terminals: High pot test, one minute 10,000 VDC Operating maximum 5,000 VDC Across End Terminals: 3500 VDC. Load not to exceed wattage rating. Tapers: Linear Taps: None Switches: None Shaft Information Diameter: .250" + .000" .002. Length: As required, in increments of 16. Trim: Available shaft trim shown in General Information. Angle of Rotation Total Rotation: 250 + 5 Effective Rotation: 234 (approx.) Mounting Bushing Information Standard Bushing: EIA standard %-32 NEF-2 A thread. Standard Lengths: Vs", e", and V2". Special Lengths: Available as required. Mounting Hardware Available hardware shown in General Information. Unless specified, controls supplied less hardware. Locating Lug Left side with terminals down. Finish Standard commercial or salt spray materials. Data Sheet 1600C CTS CORPORATION AND DIVISIONS / MANUFACTURERS OF ELECTRONIC COMPONENTSMbp 20/2 120 dia | | 4 zi | Me [a 02 27/16 +1 lb j 3/832 net-2A thd we |" ; Me \4 a ami le 1/8 3/32 dia. holes * 1.31 /32- =I CTS series HVC high voltage variable resistor GENERAL TOLERANCES: Decimal dimensions +.005. Fractional dimensions + 1/64. Order From: CTS CORPORATION, ELECTROMECHANICAL DIVISION 1142 West Beardsley Avenue/Elkhart, Indiana 46514/(219) 295-3575 5M-4-90B