PHOENIX CONTACT’s SUBCON product provides a means to make D-SUB cable assemblies without the hassle of soldering
or crimping. The SUBCON product provides connection from the pins of a D-SUB connector to individual screw actuated
terminal blocks all in a D-SUB clamshell housing. This means that the only tool required to configure a cable is a screwdriver.
Features:
Metallized Housing
Integral Jack Screws
Integral Strain Relief
D-SUB to MKDSC 1.5 Terminal Blocks
9/25 Pin Male or Female Versions
Max. Cable Diameter: 10 mm; AWG 26-14
Benefits:
EMI/RFI Shielded (Ideal for Sensitive Communication
Signals)
Secure Connection of Cable Assembly to Mating
Receptacle
Secure Connection of SUBCON to Cable
Easy Means to Construct Cable Assemblies; No More
Soldering or Crimping; Wide Range of Product to Suit
Common Applications
SUBCON Varioface Series
Interface Converters
Interface Isolator —
RS-232/RS232
The RS-232 interface is an asymmetrical voltage interface (common signal earth for all signals). In addition to a very low
signal output, the interface is characterized by the signal earth being connected to the ground chassis housing. The
consequence is very low interference resistance and a range of a maximum of 15 m. A considerable increase in the
interference-resistance in industrial applications can be achieved by the use of RS-232 isolator modules. The high-grade 3-
way isolation between both interface sides, supply and ground potentials provide a floating and interference-resistant RS-
232 interface. The positive side-effect: The expensive terminal equipment is also protected from damage by this decoupling.
Interface Converter — RS232/RS485
The RS-485 standard is used when more than two participants have to communicate.
Converting the point-to-point interface, RS-232 to the bus-capable RS-485 standard
makes it possible to network up to 32 terminals via a 2- or 4-wire line.
The Following Tasks Can Be Solved with this Converter:
Coupling an RS-232 Master Interface to an RS-485 Bus System
Integrating an RS-232 Terminal in an RS-485 Bus System
Networking of Up to 32 RS-232 Interfaces Via the RS-485 Standard (Provided They Can Be
Addressed)
Setting Up a Temporary Programming and Parameterizing Link Between PC and PLC or Drive
Regulators, for Example, with an RS-485 Connection 2744416
Stock
No.
Mfr.’s
Type
Phoenix
No. Description EACH
909-0039 2744416 PSM-ME-RS 232/RS485-P Control Cabinet Interface Module, 22.5 mm Housing 305.91
Stock
No.
Mfr.’s
Type
Phoenix
No. Description EACH
909-0041 2744461 PSM-ME-RS 232/RS232-P Converter; Rail; Serial 305.91
Interface Products and Surge Protection
2761499
AC Power Surge Protection
Complete offering of surge protection for Remote Sites, Service Entrance, Sub Panels and Cabinet Controls.
Remote Site Surge Protection
Locations away from main facilities exposed to large surge currents such as lightening strikes. Available in NEMA 4 indoor/outdoor enclosure and stainless steel for
corrosive environments. Includes remote monitoring and lights.
Service Entrance Surge Protection
Blocks surges entering the facility from the feed from the utility. Exposed to large surge line follow currents. Includes surge counter, audible alarm and remote monitoring.
Sub Panel Surge Protection
Internally generated surges, such as those from motors, drives, and compressors are prevented from traveling throughout your facility and damaging sensitive
equipment. Provides cascade protection, when used with service entrance protection. Includes audible alarm and remote monitoring.
DATASHEET
ONLINE
Control Cabinet Surge Protection
Prevents surges from damaging sensitive equipment controlling critical processes. The protection can be mounted externally to the cabinet or internally on the DIN
rail. Available in single- and 3-phase.
5602201
DATASHEET
ONLINE
Stock
No.
Mfr.’s
Type
Phoenix
No. Description EACH
909-0185 5602201 SYS N4/I FT+CT-VAL 480/277 Surge Protection for 480/244 VAC 3-Phase 3058.21
909-0194 5602746 SYS N4X/I FT+CT-VAL 480/277 Surge Protection for 480/244 VAC 3-Phase-Stainless Steel 3639.77
909-0189 5603420 SYS N4/I FT+CT-VAL 480 DELTA Surge Protection for 480 VAC 3-Phase Underground Delta 3059.09
909-0198 5603421 SYS N4X/I FT+CT-VAL 480 DELTA Surge Protection for 480 VAC 3-Phase Underground Delta-Stainless Steel 3639.77
909-0186 5602202 SYS N4/I FT+CT-VAL 208/120 Surge Protection for 208/120 VAC 3-Phase 3059.09
909-0195 5602747 SYS N4X/I FT+CT-VAL 208/120 Surge Protection for 208/120 VAC 3-Phase-Stainless Steel 3639.77
909-0187 5603416 SYS N4/I FT+CT-VAL 240/120 Surge Protection for 240/120 VAC Split Single-Phase 2353.66
909-0196 5603417 SYS N4X/I FT+CT-VAL 240/120 Surge Protection for 240/120 VAC Split Single-Phase-Stainless Steel 2675.78
Stock
No.
Mfr.’s
Type
Phoenix
No. Description EACH
909-0044 2761499 SUBCON 9/F-SH Socket, 9-Position 46.08
909-0045 2761509 SUBCON 9/M-SH Pin, 9-Position 46.08
909-0448 2761596 SUBCON 15/F-SH Socket, 15-Position 39.77
909-0449 2761606 SUBCON 15/M-SH Pin, 15-Position 39.77
909-0450 5604603 SUBCON 15 HD/F-SH Socket, 15-Position — High-Density 43.87
909-0451 5604602 SUBCON 15HD/M-SH Pin, 15-Position — High-Density 43.87
909-0046 2761619 SUBCON 25/F-SH Socket, 25-Position 51.68
909-0047 2761622 SUBCON 25/M-SH Pin, 25-Position 47.70
909-0452 2300986 SUBCON 37/F-SH Socket, 37-Position 60.17
909-0453 2300973 SUBCON 37/M-SH Pin, 37-Position 60.17
909-0454 2708232 SUBCON-PLUS-PROFIB/SC2 Profibus Connector, up to 12 Mbps, Angled
Version, Integrated terminating Resistor that
connected externally
36.35
909-0455 2708245 SUBCON-PLUS-PROFIB/PGSC2 Same as above but with additional PG SUB-D
Female Connector for the Connection of
Programming Device
41.93
909-0456 2744380 SUBCON-PLUS-PROFIB/AX/SC Profibus Connector, up to 12 Mbps, Axial
Version, Integrated terminating Resistor that
connected externally
36.35
Stock
No.
Mfr.’s
Type
Phoenix
No. Description EACH
909-0631 2804092 VAL-SQ SE 200-277/480Y/FM Surge Protection for 277/480 VAC Wye, 3-Phase 2800.00
909-0632 2804160 VAL-SQ SE 200-480D/FM Surge Protection for 480 VAC Delta, 3-Phase 2800.00
909-0633 2803933 VAL-SQ SE 200-120/208Y/FM Surge Protection for 120/208 VAC Wye, 3-Phase 2800.00
909-0634 2804047 VAL-SQ SE 200-120/240S/FM Surge Protection for 120/240 VAC, Split-Phase 2800.00
Stock
No.
Mfr.’s
Type
Phoenix
No. Description EACH
909-0635 2804063 VAL-SQ SP 120-277/470Y/FM Surge Protection for 277/480 VAC Wye, 3-Phase 1250.00
909-0636 2803904 VAL-SQ SP 120-120/208Y/FM Surge Protection for 120/208 VAC Wye, 3-Phase 1250.00
909-0637 2804018 VAL-SQ SP 120-120/240S/FM Surge Protection for 120/240 VAC Split-Phase 1250.00
Stock
No.
Mfr.’s
Type
Phoenix
No. Description EACH
909-0638 2803881 VAL-SQ CC 40-120/208 Surge Protection for 120/208 VAC Wye, 3-Phase — Externally Mounted 660.00
909-0343 2859453 VAL-CP-3S-175 Surge Protection for 120/208 VAC Wye, 3-Phase — DIN Rail Mounted —
Hot Swappable Plus Remote Monitoring
301.79
909-0639 2803991 VAL-SQ CC 40-120/240S Surge Protection for 120/240 VAC, Split-Phase — DIN Rail Mounted — Externally Mounted 660.00
909-0349 2859482 VAL-CP-2C-175 Surge Protection for 120/240 VAC, Split-Phase — DIN Rail Mounted —
Hot Swappable Plus Remote Monitoring
167.93
809-0633 2856812 PT2-PE/S-120AC Surge Protection for 120 VAC, Single-Phase — DIN Rail Mounted —
Hot Swappable Plus Remote Monitoring
119.76
909-0217 2858357 PT2-PE/S-230AC Surge Protection fro 230 VAC, Single-Phase — DIN Rail Mounted —
Hot Swappable Plus Remote Monitoring
121.54
RoHSRoHS
2804092
2804063
2803881
1324
16
16
INDUSTRIAL CONTROL
1324-2008 9/5/08 10:56 AM Page 1324
