Description
Features
n5000 WATT PEAK POWER PROTECTION
nEXCELLENT CLAMPING CAPABILITY
nFAST RESPONSE TIME
Mechanical Dimensions
nTYPICAL IR < 1µA ABOVE 10V
n
GLASS PASSIVATED CHIP CONSTRUCTION
nMEETS UL SPECIFICATION 94V-0
Maximum Ratings
Peak Power Dissipation...PPK
TP = 1ms (Note 5)
Steady State Power Dissipation...PD
@ TL = 75°C
Non-Repetitive Peak Forward Surge Current...IFSM
@ Rated Load Conditions, 8.3 ms, ½ Sine Wave, Single Phase
(Note 3)
Weight...GRM
Soldering Requirements (Time & Temp)...ST
@ 250°C
Operating & Storage Temperature Range...TJ, TSTRG
5KP Series
Data Sheet
5.0V to 110V GPP TRANSIENT
VOLTAGE SUPPRESSORS
5KP Series
Units
Watts
Watts
Amps
Grams
......................................... 5000 ..........................................
............................................. 5 ...............................................
............................................. 400 ...............................................
............................................. 2.10 ...............................................
......................................... 10 Sec. ..........................................
......................................... -55 to 175 .......................................... °C
Page 11-18
Min. to
Solder
NOTES: 1. For Bi-Directional Applications, Use C or CA. Electrical Characteristics Apply in Both Directions.
2. Mounted on 20mm2 Copper Pads.
3. 8.3 ms, ½ Sine Wave, Single Phase Duty Cycle, @ 4 Pulses Per Minute Maximum.
4. VBR Measured After IT Applies for 300 µs. IT = Square Wave Pulse or Equivalent.
5. Non-Repetitive Current Pulse. Per Fig. 3 and Derated Above TA = 25°C Per Fig. 2.
.340
.360
1.00 Min.
.050 typ.
.340
.360
JEDEC
R6
Uni-Polar
Load
TVS
Device
TVS
Device
Load
Bi-Polar