Power Inductor Electrical Requirements (at 25C) Test Condition 1KHz 0.25V L 1mH 20% at 25C DCR 6.37(Max.) 1KHz 0.25V Irated 0.15A Rated Current: The rated current is the current at which the inductance decreases by 35% from the initial value or the temperature rise is T=40C ,whichever is smaller. Operating Temperature : -40C to +100C ! A D B E A MARK F C H G I ! Dimensions: A 7 0.3mm B 3.4 0.3 mm C 2.0 0.1 mm D 4.9 0.2 mm E 0.9 0.1 mm F 1.5mm G 1.5 mm H 4.9 mm I 2.2mm Schematic Diagram Part Number Table Description Part Number Inductor, 1mH, 0.15A, 6.37 DCR MCSDRB7032-102MHF Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. (c) Premier Farnell plc 2012. www.element14.com www.farnell.com www.newark.com Page <1> 11/06/14 V1.0