Copyright © 1999 New Japan Radio Co., Ltd. Rev.04 External Ku-PLL LNB
External Reference Type Ku-band PLL LNB
MODEL NO. NJR2633E / EN0 MODEL NO. NJR2636E / EN0
MODEL NO. NJR2634E / EN0 MODEL NO. NJR2637E / EN0
MODEL NO. NJR2635E / EN0 MODEL NO. NJR2639E / EN0
<Description>
This specification defines the Low Noise Block downconverter (LNB) intended for the satellite data communication
downlink application in the Ku-band. This LNB has a combined 3-stage HEMT amplifier and block downconverter
with Phase Locked Local, which is constituted with a VCO, SPD (Sampling Phase Detector), Loop Filter and
Reference Recovery VCXO providing low phase noise. All specifications shall apply throughout the full range of the
specified environmental conditions unless otherwise specified.
<Line-Up>
Model No. RF Frequency Local Frequency Local Stability IF Frequency
NJR2637E / EN0 10.95 to 11.70 GHz 10.00 GHz 950 to 1,700 MHz
NJR2639E / EN0 11.20 to 11.70 GHz 10.25 GHz 950 to 1,450 MHz
NJR2633E / EN0 11.45 to 11.95 GHz 10.50 GHz Depends on 950 to 1,450 MHz
NJR2635E / EN0 11.70 to 12.20 GHz 10.75 GHz External reference 950 to 1,450 MHz
NJR2634E / EN0 12.20 to 12.70 GHz 11.25 GHz 950 to 1,450 MHz
NJR2636E / EN0 12.25 to 12.75 GHz 11.30 GHz 950 to 1,450 MHz
<Specifications>
Item Specifications
Input Waveguide Flange WR75
Output Connector Type F-female (75 ohm)
<Model No. NJR2633E / 34E / 35E / 36E / 37E / 39E >
Type N-female (50 ohm)
<Model No. NJR2633EN0 / 34EN0 / 35EN0 / 36EN0 / 37EN0 / 39EN0 >
Option1: N-male, Option2: TNC female
Noise Figure (at 25 °C)0.9 dB typ.
Conversion Gain (at 25 °C)55 dB min. 60 dB typ.
Conversion Gain Variation
(at 25 °C)2 dB max. In any 50 MHz segment over the frequency band.
P1dB +10 dBm min.
Phase Noise (SSB) -63 dBc/Hz at 100 Hz
-73 dBc/Hz at 1 kHz
-83 dBc/Hz at 10 kHz
-93 dBc/Hz at 100 kHz
External Reference Input Frequency 10 MHz
External Reference Input Power -10 to 0 dBm (75ohm or 50 ohm) @ IF output connector
External Reference Input Port IF output connector (combine reference with IF signal)
External Reference Phase Noise -135 dBc/Hz at 100Hz
-143 dBc/Hz at 1kHz
-145 dBc/Hz at 10kHz (Input Condition)
Spurious -140 dBm max.
At input, fixed frequency spurious, unrelated to test CW signal.
-50 dBc max. With test CW signal -10dBm IF output.
(measured at specified IF band ; 950 to 1,450 MHz or 1,700MHz)