ATV212HD15N4 Product data sheet Characteristics Disclaimer: This documentation is not intended as a substitute for and is not to be used for determining suitability or reliability of these products for specific user applications variable speed drive ATV212 - 15kW - 20hp 480V - 3ph - EMC - IP21 Main Range of product Altivar 212 Product or component type Variable speed drive Device short name ATV212 Product destination Asynchronous motors Product specific application Pumps and fans in HVAC Assembly style With heat sink Network number of phases 3 phases Motor power kW 15kW Motor power hp 20hp [Us] rated supply voltage 380...480 V - 15...10 % Supply voltage limits 323...528V Supply frequency 50...60 Hz - 5...5 % EMC filter Class C2 EMC filter integrated Line current 22.8A at 480 V 28.5A at 380 V Complementary Apparent power 23.2kVA at 380 V Prospective line Isc 22kA Continuous output current 30.5A at 380 V 30.5A at 460 V Maximum transient current 33.6A for 60 s Speed drive output frequency 0.5...200Hz Nominal switching frequency 12 kHz Switching frequency 6...16 kHz adjustable 12...16 kHz with derating factor Speed range 1...10 Jan 24, 2021 1 Speed accuracy +/- 10 % of nominal slip 0.2 Tn to Tn Torque accuracy +/- 15 % Transient overtorque 120% of nominal motor torque +/- 10 % for 60 s Asynchronous motor control profile Flux vector control without sensor, standard Voltage/frequency ratio, 2 points Voltage/frequency ratio, automatic IR compensation (U/f + automatic Uo) Voltage/frequency ratio - Energy Saving, quadratic U/f Voltage/frequency ratio, 5 points Regulation loop Adjustable PI regulator Motor slip compensation Automatic whatever the load Not available in voltage/frequency ratio motor control Adjustable Local signalling 1 LED (red) for DC bus energized Output voltage <= power supply voltage Isolation Electrical between power and control Type of cable Without mounting kit: 1 wire(s)IEC cable at 45C, copper 90 C / XLPE/EPR Without mounting kit: 1 wire(s)IEC cable at 45C, copper 70 C / PVC With UL Type 1 kit: 3 wire(s)UL 508 cable at 40C, copper 75 C / PVC Electrical connection VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES: terminal 2.5mm / AWG 14 L1/R, L2/S, L3/T: terminal 25mm / AWG 3 Tightening torque 0.6N.m (VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES) 4.5N.m, 40 lb.in (L1/R, L2/S, L3/T) Supply Internal supply for reference potentiometer (1 to 10 kOhm): 10.5 V DC +/- 5 %, <10A, protection type: overload and short-circuit protection Internal supply: 24 V DC (21...27V), <200A, protection type: overload and short-circuit protection Analogue input number 2 Analogue input type VIA switch-configurable voltage: 0...10 V DC 24 V max, impedance: 30000 Ohm, resolution 10 bits VIB configurable voltage: 0...10 V DC 24 V max, impedance: 30000 Ohm, resolution 10 bits VIB configurable PTC probe: 0...6 probes, impedance: 1500 Ohm VIA switch-configurable current: 0...20 mA, impedance: 250 Ohm, resolution 10 bits Sampling duration 2ms +/- 0.5 ms F discrete 2ms +/- 0.5 ms R discrete 2ms +/- 0.5 ms RES discrete 3.5ms +/- 0.5 ms VIA analog 22ms +/- 0.5 ms VIB analog Response time FM 2 ms, tolerance +/- 0.5 ms for analog output(s) FLA, FLC 7 ms, tolerance +/- 0.5 ms for discrete output(s) FLB, FLC 7 ms, tolerance +/- 0.5 ms for discrete output(s) RY, RC 7 ms, tolerance +/- 0.5 ms for discrete output(s) Accuracy +/- 0.6 % (VIA) for a temperature variation 60 C +/- 0.6 % (VIB) for a temperature variation 60 C +/- 1 % (FM) for a temperature variation 60 C Linearity error VIA: +/- 0.15 % of maximum value for input VIB: +/- 0.15 % of maximum value for input FM: +/- 0.2 % for output Analogue output number 1 Analogue output type FM switch-configurable voltage 0...10 V DC, impedance: 7620Ohm, resolution 10 bits FM switch-configurable current 0...20 mA, impedance: 970Ohm, resolution 10 bits Discrete output number 2 Discrete output type Configurable relay logic: (FLA, FLC) NO - 100000cycles Configurable relay logic: (FLB, FLC) NC - 100000cycles Configurable relay logic: (RY, RC) NO - 100000cycles Minimum switching current 3mA at 24 V DC for configurable relay logic Maximum switching current 5A at 250 V AC on resistive load - cos phi = 1 - L/R = 0 ms (FL, R) 5A at 30 V DC on resistive load - cos phi = 1 - L/R = 0 ms (FL, R) 2A at 250 V AC on inductive load - cos phi = 0.4 - L/R = 7 ms (FL, R) 2A at 30 V DC on inductive load - cos phi = 0.4 - L/R = 7 ms (FL, R) Discrete input type F programmable 24 V DC, with level 1 PLC, impedance: 4700 Ohm R programmable 24 V DC, with level 1 PLC, impedance: 4700 Ohm RES programmable 24 V DC, with level 1 PLC, impedance: 4700 Ohm Discrete input logic Positive logic (source) (F, R, RES), <= 5 V (state 0), >= 11 V (state 1) Negative logic (sink) (F, R, RES), >= 16 V (state 0), <= 10 V (state 1) Acceleration and deceleration ramps Linear adjustable separately from 0.01 to 3200 s Automatic based on the load 2 Braking to standstill By DC injection Protection type Overheating protection: drive Thermal power stage: drive Short-circuit between motor phases: drive Input phase breaks: drive Overcurrent between output phases and earth: drive Overvoltages on the DC bus: drive Break on the control circuit: drive Against exceeding limit speed: drive Line supply overvoltage and undervoltage: drive Line supply undervoltage: drive Against input phase loss: drive Thermal protection: motor Motor phase break: motor With PTC probes: motor Dielectric strength 3535V DC between earth and power terminals 5092V DC between control and power terminals Insulation resistance >= 1 mOhm 500 V DC for 1 minute Frequency resolution Display unit: 0.1 Hz Analog input: 0.024/50 Hz Communication port protocol BACnet Modbus METASYS N2 APOGEE FLN LonWorks Connector type 1 open style 1 RJ45 Physical interface 2-wire RS 485 Transmission frame RTU Transmission rate 9600 bps or 19200 bps Data format 8 bits, 1 stop, odd even or no configurable parity Type of polarization No impedance Number of addresses 1...247 Communication service Time out setting from 0.1 to 100 s Read device identification (43) Monitoring inhibitable Write single register (06) Write multiple registers (16) 2 words maximum Read holding registers (03) 2 words maximum Option card Communication card for LonWorks Operating position Vertical +/- 10 degree Width 245mm Height 330mm Depth 190mm Net weight 11.65kg Power dissipation in W 625W Air flow 206m3/h Functionality Mid Specific application HVAC IP degree of protection IP21 Variable speed drive application selection Compressor for scroll Building - HVAC Fan Building - HVAC Pump Building - HVAC Motor power range AC-3 15...25kW at 380...440V 3 phases 15...25kW at 480...500V 3 phases Motor starter type Variable speed drive Environment Electromagnetic compatibility Electrostatic discharge immunity test level 3 conforming to IEC 61000-4-2 Radiated radio-frequency electromagnetic field immunity test level 3 conforming to IEC 61000-4-3 Electrical fast transient/burst immunity test level 4 conforming to IEC 61000-4-4 1.2/50 s - 8/20 s surge immunity test level 3 conforming to IEC 61000-4-5 3 Conducted radio-frequency immunity test level 3 conforming to IEC 61000-4-6 Voltage dips and interruptions immunity test conforming to IEC 61000-4-11 Pollution degree 2 conforming to IEC 61800-5-1 IP degree of protection IP20 on upper part without blanking plate on cover conforming to EN/IEC 61800-5-1 IP20 on upper part without blanking plate on cover conforming to EN/IEC 60529 IP21 conforming to EN/IEC 61800-5-1 IP21 conforming to EN/IEC 60529 IP41 on upper part conforming to EN/IEC 61800-5-1 IP41 on upper part conforming to EN/IEC 60529 Vibration resistance 1.5 mm (f= 3...13Hz) conforming to EN/IEC 60068-2-6 1 gn (f= 13...200Hz) conforming to EN/IEC 60068-2-8 Shock resistance 15 gn for 11ms conforming to IEC 60068-2-27 Environmental characteristic Classes 3C1 conforming to IEC 60721-3-3 Classes 3S2 conforming to IEC 60721-3-3 Noise level 54dB conforming to 86/188/EEC Operating altitude 1000...3000 m limited to 2000 m for the Corner Grounded distribution network with current derating 1 % per 100 m <= 1000 m without derating Relative humidity 5...95% without condensation conforming to IEC 60068-2-3 5...95% without dripping water conforming to IEC 60068-2-3 Ambient air temperature for operation -10...40C (without derating) 40...50C (with derating factor) Ambient air temperature for storage -25...70C Standards IEC 61800-3 category C2 EN 61800-3 category C3 IEC 61800-3 category C3 IEC 61800-5-1 EN 61800-3 environments 2 category C1 EN 55011 class A group 1 IEC 61800-3 environments 2 category C2 EN 61800-3 environments 2 category C2 IEC 61800-3 environments 1 category C2 IEC 61800-3 environments 1 category C3 EN 61800-5-1 UL Type 1 IEC 61800-3 environments 2 category C3 EN 61800-3 category C2 EN 61800-3 environments 1 category C3 IEC 61800-3 EN 61800-3 environments 1 category C2 EN 61800-3 environments 2 category C3 IEC 61800-3 environments 1 category C1 EN 61800-3 IEC 61800-3 environments 2 category C1 EN 61800-3 environments 1 category C1 Product certifications CSA UL C-Tick NOM 117 Marking CE Packing Units Unit Type of Package 1 PCE Number of Units in Package 1 1 Package 1 Weight 11.646kg Package 1 Height 27.5cm Package 1 width 39.5cm Package 1 Length 30cm Unit Type of Package 2 P06 Number of Units in Package 2 4 Package 2 Weight 59.58kg Package 2 Height 80cm Package 2 width 80cm 4 Package 2 Length 60cm Offer Sustainability Sustainable offer status Green Premium product REACh Regulation REACh Declaration EU RoHS Directive Pro-active compliance (Product out of EU RoHS legal scope) EU RoHS Declaration Mercury free Yes RoHS exemption information Yes China RoHS Regulation China RoHS declaration Environmental Disclosure Product Environmental Profile Circularity Profile End of Life Information WEEE The product must be disposed on European Union markets following specific waste collection and never end up in rubbish bins Contractual warranty Warranty 18 months 5