2N6505G - LITTELFUSE - Pdf.Support

Thyristors Datasheet

Speciﬁcations are subject to change without notice.

Revised: GD. 02/12/21

2N6504 Series

Surface Mount – 50 - 800V

■Glass Passivated Junctions

for Greater Parameter

Uniformity and Stability

■Small, Rugged, Thermowatt

Construction for Low Thermal

Resistance, High Heat

Dissipation and Durability

■Blocking Voltage to 800 Volts

■300 A Surge Current

Capability

■ Pb−Free Package is Available

Features

The 2N6504 is designed primarily for half-wave AC control

applications, such as motor controls, heating controls and power

supply crowbar circuits.

Description

Additional Information

Pin Out

TO-220AB

Case 221A

Style 4

Functional Diagram

Resources Accessories Samples

Thyristors Datasheet

Speciﬁcations are subject to change without notice.

Revised: GD. 02/12/21

2N6504 Series

Surface Mount – 50 - 800V

Rating Symbol Value Unit

Peak Repetitive Off-State Voltage (Note 1)

(Gate Open, Sine Wave 50 to 60 Hz, TJ = 25 to 125°C)

2N6504

2N6505

2N6507

2N6508

2N6509

VDRM,

VRRM

100

400

600

800

On-State RMS Current (180° Conduction Angles; TC = 85°C) IT (RMS) 25 A

Average On-State Current (180° Conduction Angles; TC = 85°C) IT (AV) 16 A

Peak Non-repetitive Surge Current

(1/2 Cycle, Sine Wave 60 Hz, TJ = 100°C) ITSM 250 A

Forward Peak Gate Power (Pulse Width ≤ 1.0 µs, TC = 85°C) PGM 20 W

Forward Average Gate Power (t = 8.3 ms, TC = 85°C) PG(AV) 0.5 W

Forward Peak Gate Current (Pulse Width ≤ 1.0 µs, TC = 85°C) IGM 2.0 A

Operating Junction Temperature Range TJ-40 to +125 °C

Storage Temperature Range Tstg -40 to +150 °C

Maximum Ratings (TJ = 25°C unless otherwise noted)

Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the

Recommended Operating Conditions may affect device reliability.

1. VDRM and VRRM for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage; however, positive gate voltage shall not be applied concurrent with negative potential on the anode. Blocking voltages

shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded.

Thermal Characteristics

Rating Symbol Value Unit

*Thermal Resistance, Junction to Case RƟJC 1. 5 °C/W

*Maximum Lead Temperature for Soldering Purposes, 1/8” from case for

10 seconds TL260 °C

* Indicates JEDEC Registered Data.

Electrical Characteristics - OFF (TC = 25°C unless otherwise noted)

Characteristic Symbol Min Ty p Max Unit

†Peak Repetitive Blocking Current

(VAK = VDRM = VRRM; Gate Open)

TJ = 25°C

TJ = 125°C

IDRM,

IRRM

- - 10 µA

- - 2.0 mA

Electrical Characteristics - ON (TC = 25°C unless otherwise noted; Electricals apply in both

directions)

*Indicates JEDEC Registered Data

2. Pulse Test: Pulse Width ≤ 300 µsec, Duty Cycle ≤ 2%.

Characteristic Symbol Min Ty p Max Unit

* Forward On-State Voltage (Note 2) (ITM = 50 A) VTM − − 1. 8 V

* Gate Trigger Current (Continuous dc)

(VAK = 12 Vdc, RL = 100 )

TC = 25°C

TC = -40°C IGT

− 9.0 30 mA

− − 75

* Gate Trigger Voltage (Continuous dc) (VAK = 12 Vdc, RL = 100 Ω, TC = -40 °C) VGT −1. 0 1. 5 V

Gate Non-Trigger Voltage (VAK = 12 Vdc, RL = 100 Ω, TJ = 125°C) VGD 0.2 − − V

*Holding Current (VD = 12 Vdc,

Initiating Current = 200 mA, Gate Open)

TC = 25°C

TC = -40°C IH

-18 40 mA

- - 80

* Turn-On Time (ITM = 25 A, IGT = 50 mAdc) tgt - - - µs

Turn-Off Time (VRM = rated voltage) (ITM = 25 A, IR = 25 A) tq- - - µs

Thyristors Datasheet

Speciﬁcations are subject to change without notice.

Revised: GD. 02/12/21

2N6504 Series

Surface Mount – 50 - 800V

Figure 1. AverageCurrent Derating Figure 2. Maximum On-State Power Dissipation

Dynamic Characteristics

Characteristic Symbol Min Ty p Max Unit

Critical Rate of Rise of Off-State Voltage (Gate Open, Rated VDRM,

Exponential Waveform) dv/dt(c) − 50 − V/µs

Voltage Current Characteristic of SCR

Symbol Parameter

VDRM Peak Repetitive Forward Off State Voltage

IDRM Peak Forward Blocking Current

VRRM Peak Repetitive Reverse Off State Voltage

IRRM Peak Reverse Blocking Current

VTM Maximum On State Voltage

IHHolding Current

Quadrant 1

Main Terminal 2+

VTM

IDRM at VDRM

oltage

Off State

Quadrant 3

Main Terminal 2-

+Current

On State

IRRM at VRRM

VTM

Thyristors Datasheet

Speciﬁcations are subject to change without notice.

Revised: GD. 02/12/21

2N6504 Series

Surface Mount – 50 - 800V

Figure 4. Maximum Non−Repetitive Surge CurrentFigure 3. Typical On−State Characteristics

Figure 5. Thermal Response

Thyristors Datasheet

Speciﬁcations are subject to change without notice.

Revised: GD. 02/12/21

2N6504 Series

Surface Mount – 50 - 800V

Figure 6. Typical Gate Trigger Current vs. Junction

Temperature

Typical Trigger Characteristics

Figure 7. Typical Gate Trigger Voltage vs. Junction

Temperature

Figure 8. Typical Holding Current vs.Junction

Temperature

Thyristors Datasheet

Speciﬁcations are subject to change without notice.

Revised: GD. 02/12/21

2N6504 Series

Surface Mount – 50 - 800V

Dimensions Part Marking System

12 3

PLANE

SEATING

Ordering Information

1. Dimensioning and tolerancing per ansi y14.5m, 1982.

2. Controlling dimension: inch.

3. Dimension z deﬁnes a zone where all body and lead irregularities are allowed.

Dim Inches Millimeters

Min Max Min Max

A0.590 0.620 14.99 15.75

B0.380 0.420 9.65 10.67

C0.178 0.188 4.52 4.78

D0.025 0.035 0.64 0.89

F0.142 0.147 3.61 3.73

G0.095 0.105 2.41 2.67

H0.110 0.13 0 2.79 3.30

J0.018 0.024 0.46 0.61

K0.540 0.575 13.72 14.61

L0.060 0.075 1.52 1.91

N0.195 0.205 4.95 5.21

Q0.105 0.115 2.67 2.92

R0.085 0.095 2.16 2.41

S0.045 0.060 1. 14 1.52

T0.235 0.255 5.97 6.47

U0.000 0.050 0.00 1.27

V0.045 --- 1. 15 ---

Z--- 0.080 --- 2.04

Disclaimer Notice - Information furnished is believed to be accurate and reliable. However, users should independently evaluate the suitability of and test each product selected for their own applications. Littelfuse products are

not designed for, and may not be used in, all applications. Read complete Disclaimer Notice at http://www.littelfuse.com/disclaimer-electronics.

Pin Assignment

1 Cathode

2 Anode

3 Gate

4 Anode

TO-220AB

Case 221A

Style 3

YMAXX

2N650xG

AKA

Y =Year

M =Month

A =Assembly Site

AKA =Diode Polarity

G =Pb-Free Package

Device Package Shipping

2N6504 TO-220AB

1000 Units / Box

2N6504G TO-220AB

(Pb-Free)

2N6505 TO-220AB

2N6505G TO-220AB

(Pb-Free)

2N6505T TO-220AB

1000 Units / Box

2N6505TG TO-220AB

(Pb-Free)

2N6507 TO-220AB

1000 Units / Box

2N6507G TO-220AB

(Pb-Free)

2N6507T TO-220AB

1000 Units / Box

2N6507TG TO-220AB

(Pb-Free)

2N6508 TO-220AB

1000 Units / Box

2N6508G TO-220AB

(Pb-Free)

2N6508TG TO-220AB 1000 Units / Box

2N6509 TO-220AB

(Pb-Free) 1000 Units / Box

2N6509G TO-220AB

2N6509T TO-220AB

(Pb-Free) 1000 Units / Box

2N6509TG TO-220AB