InNET TECHNOLOGIES SI-20012 Electrical ELECTRICAL SPECIFICATIONS (REV. x1) INDUCTANCE : (P6-J6) ; (P5J5) ; (P4U4) ; (P3-J3) : 3.5mH MIN. @ .O1V, 10KHz DC RESISTANCE: P6-J6 : 1.0 ohm MAX. a Js P5-J5 : 1.0 ohm MAX. J7 BULL 46 P4u4 : 1.0 ohm MAX. SUL a JS P3-u3 : 1.0 ohm MAX. 4. BUILT a 4 i) BULL a 3 COMMON MODE ATTENUATION : CMA (-dB) 3 a 2 a Ji FREQUENCY (MHz) TYPICAL MIN 100 KHz 31 25 1 MHz 42 34 2 MHz 42 34 6 MHz 37 30 10 MHz 33 25 Mechanical = +P. [375] (16) (REV. 02) By 3 Ze $8 [> 44 [87.73]Max 2 2 = 2 z a | i t g 865 MAX > g fh #3,512 [89.20] Ee Ref. eS .. .040 [1.02K7) 3 .005 = 6.083 [2.12\(7) Py Ref. 25 bk FSA out #2 GEM .275 [6.99] | - [6.99] .050 [1.27] TYP TOL NON-ACCUM .550 [13.97] TYP .025 [0.63] a #.066 [1.68] (5 nm | [1.68] (5) .100 [2.54] TYP 6, } #3,200 [61.28] | #.035 [0.89] (48) TOL NON-ACCUM F i = Nels 4 Lt oto S28 oohe wake eke Leela aah e et li oe $$-$-{)-_-4-}}-$_}--h-)- 6--}>- p--Ip- < | 3 s oo 8 3/2 = sis NOTES: a TTT TTT TT TT TT 019 128 [3.25] TOLERANCES COMPLY WITH F.C.C. DIMENSION. REQUIREMENTS =I$ os ray 2 #.085 [2.16] (2) DIMENSIONS SHOWN WITH * TO BE CENTRAL ABOUT CENTER LINE **#" ON DIMENSION INDICATES HIGHEST POINT OF BEAM PIN NOT ELECTRICALLY CONNECTED MAYBE OMITTED. SEE ELECTRICAL DRAWING FOR OMITTED PINS. AVAILABLE WITH: STANDARD 50 MICRO-INCH SELECTIVE GOLD PLATING WEBSITE. innet-tech.com #3.200 [81.28] *3.420 [86.87] P.C.B. RECOMMENDED HOLE LAYOUT SEEN FROM COMPONENT SIDE TOLERANCE +.003 [0.08] UNLESS OTHERWISE SPECIFIED E-MAIL innet@innet-tech.com NORTH AMERICA tel 858-578-8094 fax 858-578-5762 HONG KONG CHINA tel 852-2690-1049 tel 86-769-229-2901 fax 852-2687-6441 fax 86-769-225-0747