EB01-FS150R12KE3G Data Sheet EB01-FS150R12KE3G Basic Board for Infineon EconoPACK+ Modules FS150R12KE3G Abstract The EB01-FS150R12KE3G is a basic board to be used with six-channel driver 6SD312EI for reliable driving and safe operation of Infineon IGBT modules FS150R12KE3G. The basic board EB01-FS150R12KE3G (with driver 6SD312EI) is fully matched to IGBT module FS150R12KE3G. Its plug-and-play capability makes it ready to operate immediately after mounting. The user needs invest no effort in designing or adjusting it to a specific application. Product Highlights Plug-and-play solution Suitable for FS150R12KE3G No electrolytic capacitors Extremely reliable; long service life Shortens application development time IGBT-Driver.com Applications Three-phase inverters Motor drives UPS Power-factor correctors Wind-power converters Welding SMPS and many others Page 1 EB01-FS150R12KE3G Basic Board Data Sheet Important: Please refer to the relevant manuals! This data sheet contains only product-specific data for the basic board. Information specific to the relevant driver can be found in the corresponding data sheet. A detailed description, must-read application notes and general data applicable to this driver family are found in: "Description and Application Manual, Six-Channel Driver 6SD312EI for the EconoPACK+ Modules ". Dimensions Dimensions: 162 x 100 mm. Height including driver: 21 mm (30 mm with connector X1 and flat cable). Mounting principle: soldered onto an EconoPACK+ IGBT module FS150R12KE3G. Absolute Maximum Ratings Parameter Remarks Input power per channel Switching frequency DC link voltage Operating temperature Storage temperature Note 1 Note 2 Note 3 Min Max Units 3 69 800 -40 +85 -40 +90 W kHz V C C All data refer to +25C unless otherwise specified Page 2 CT-Concept.com EB01-FS150R12KE3G Basic Board Data Sheet Electrical Characteristics Short-circuit protection Remarks V ce -monitoring threshold Response time Betw. aux. terminals Gate output Remarks Min Typ. Max Units 3.4 10 V s Min Typ. Max Units 8.2 10 Min Typ. Max Units Note 4 Turn-on gate resistor R g(on) Turn-off gate resistor R g(off) Electrical insulation Test conditions Creep path between channels 9 mm All data refer to +25C unless otherwise specified Footnotes to the key data 1) 2) 3) 4) The input power is limited by the on-board gate resistors. If the specified max. switching frequency is exceeded, the gate resistors may overheat. This limit is due to active clamping. Refer to the "Description and Application Manual, Six-Channel Driver 6SD312EI for the EconoPACK+ Modules". Pulse width of the direct output of the gate drive unit (excluding the gate-resistor delay). IGBT-Driver.com Page 3 EB01-FS150R12KE3G Basic Board Data Sheet Important Notice The data contained in this product data sheet is intended exclusively for technically trained staff. Handling all high-voltage equipment involves risk to life. Strict compliance with the respective safety regulations is mandatory! Any handling of electronic devices is subject to the general specifications for protecting electrostatic-sensitive devices according to international standard IEC 747-1, Chapter IX or European standard EN 100015 (i.e. the workplace, tools, etc. must comply with these standards). Otherwise, this product may be damaged. Disclaimer This data sheet specifies devices but cannot promise to deliver any specific characteristics. No warranty or guarantee is given - either expressly or implicitly - regarding delivery, performance or suitability. CT-Concept Technology AG reserves the right to make modifications to its technical data and product specifications at any time without prior notice. The general terms and conditions of delivery of CT-Concept Technology AG apply. Page 4 CT-Concept.com EB01-FS150R12KE3G Basic Board Data Sheet Ordering Information The general terms and conditions of delivery of CT-Concept Technologie AG apply. Related IGBT CONCEPT Driver Type # Infineon (eupec) FS150R12KE3G 6SD312EI Connection CONCEPT Modular Cable Type # 6SD312EI to EB01-FS150R12KE3G MIC01A (6 items per driver) Related IGBT CONCEPT Basic Board Type # Infineon (eupec) FS150R12KE3G EB01-FS150R12KE3G Information about Other Products For drivers adapted to other high-voltage or high-power IGBT modules Direct link: www.IGBT-Driver.com/go/plug-and-play For other drivers and evaluation systems Please click: www.IGBT-Driver.com (c) Manufacturer CT-Concept Technologie AG Intelligent Power Electronics Renferstrasse 15 CH-2504 Biel-Bienne Switzerland Tel. Fax +41 - 32 - 344 47 47 +41 - 32 - 344 47 40 E-mail Internet Info@IGBT-Driver.com www.IGBT-Driver.com Copyright 1998...2007 by CT-Concept Technologie AG - Switzerland. We reserve the right to make any technical modifications without prior notice. IGBT-Driver.com All rights reserved. Version of 2016-05-20 Page 5 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Power Integrations: EB01-FS150R12KE3G EB01-FS300R17KE3