Classification: "Lithium Coin"
Lithium / Manganese Dioxide (Li/MnO2)
Designation: ANSI / NEDA-5003LC, IEC-CR2025
Nominal Voltage: 3.0 Volts
(Rated at 15K ohms at 21°C)
Typical Weight: 2.6 grams (0.08 oz.)
Typical Volume: 0.8 cubic centimeters (0.05 cubic inch)
Max Rev Charge: 1 microampere
Energy Density: 176 milliwatt hr/g, 616 milliwatt hr/cc
Typical Li Content: 0.078 grams (0.0028 oz.)
Operating Temp: -30C to 60C
Self Discharge: ~1% / year
15,000 890 Bkgnd Drain: Continuous
Pulse Drain: 2 seconds X 12 times/day
Simulated Application test
Typical Performance at 21°C (70°F)
Industry Standard Dimensions
(1) KEEP OUT OF REACH OF CHILDREN. Swallowing may lead to
serious injury or death in as little as 2 hours due to chemical burns and
potential perforation of the esophagus. Immediately see doctor; have
doctor phone (800) 498-8666.
(2) Battery compartment design. To prevent children from removing
batteries, battery compartments should be designed with one of the
following methods: a) a tool such as screwdriver or coin is required to open
battery compartment or b) the battery compartment door/cover requires
the application of a minimum of two independent and simultaneous
movements of the securing mechanism to open by hand. Screws should
remain captive with the battery door or cover.
Contents herein do not constitute a warranty and are for reference only.
Pulse Test at 21°C (70°F)
Typical Discharge Characteristics
Internal Resistance Characteristics
This datasheet contains typical information specific to products manufactured at the time of its publication.
1.8
2.0
2.2
2.4
2.6
2.8
3.0
3.2
0 200 400 600 800 1000
Voltage, CCV
Service, Hours
Load: 15K ohms - Continuous
Typical Drain @ 2.9V: 0.193 mA
0
20
40
60
80
100
120
1.8
2.0
2.2
2.4
2.6
2.8
3.0
3.2
025 50 75 100 125 150 170
IR, ohms
Voltage, CCV
Capacity, mAh
2.50 (0.098)
2.20 (0.087)
2.18 (0.086) Ref.
1.88 (0.074) Ref. 8.00 (0.315)
Minimum
20.00 (0.787)
19.70 (0.776)
0.20 (0.008) Maximum Ref.
Permissible deflection from a flat.
0.03 (0.001) Minimum Ref.
(Applies to top edge of gasket or
edge of crimp, whichever is higher.)
Form No. 2025NA0618 Page 1 of 1