3FN3137.6
March 4, 2009
Absolute Maximum Ratings Thermal Information
V+ to V- . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44V
V- to Ground. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25V
Digital Inputs, VS, VD (Note 1). . . . . . . . . . . . . (V- -2V) To (V+ +2V)
Continuous Current, (Any Terminal Except S or D) . . . . . . . . . 30mA
Continuous Current, (S or D). . . . . . . . . . . . . . . . . . . . . . . . . . 20mA
Peak Current, S or D (Pulsed 1ms, 10% Duty Cycle Max) . . . . . 40mA
Operating Conditions
Temperature Range
“A” Suffix. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -55oC to 125oC
“B” Suffix. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -25oC to 85oC
“C” Suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0oC to 70oC
Thermal Resistance (Typical, Note 2) θJA (oC/W) θJC (oC/W)
16 Ld CERDIP Package. . . . . . . . . . . . 75 20
16 Ld PDIP Package . . . . . . . . . . . . . . 90 N/A
Maximum Junction Temperature
CERDIP Package. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .175oC
PDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .150oC
Maximum Storage Temperature
“A” and “B” Suffix . . . . . . . . . . . . . . . . . . . . . . . . . -65oC to 150oC
“C” Suffix . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -65oC to 125oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . .300oC
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the ope rational sections of this specification is not implied.
NOTES:
1. Signals on SX, D, EN, or AX exceeding V+ or V- are clamped by in ternal diodes. Limit diode current to maximum current ratings.
2. θJA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications TA = 25oC, V+ = +15V, V- = -15V, GND = 0V, VEN = 2.4V, Unless Otherwise Specified
PARAMETER TEST CONDITIONS
“A” SUFFIX “B” AND “C” SUFFIX
UNITS
(NOTE 4)
MIN (NOTE 3)
TYP (NOTE 4)
MAX (NOTE 4)
MIN (NOTE 3)
TYP (NOTE 4)
MAX
DYNAMIC CHARACTERISTICS
Switching Time of
Multiplexer, tTRANSITION See Figure 1 - 0.6 1 - 0.6 - μs
Break-Before-Make
Interval, tOPEN See Figure 3 - 0.2 - - 0.2 - μs
Enable Turn-ON Time,
tON(EN) See Figure 2 - 1 1.5 - 1 - μs
Enable Turn-OFF Time,
tOFF(EN) See Figure 2 - 0.4 1.0 - 0.4 - μs
OFF Isolation, OIRR VEN = 0V, RL = 1kΩ, CL = 15pF,
VS=7V
RMS, f = 500kHz (Note 5) -68- -68-dB
Source OFF Capacitance,
CS(OFF) VS = 0V, VEN = 0V, f = 140kHz - 5 - - 5 - pF
Drain OFF Capacitance,
CD(OFF) VD = 0V, VEN = 0V, f = 140kHz - 25 - - 25 - pF
Charge Injection, Q See Figure 4 - 4 - - 4 - pC
DIGITAL INPUT CHARAC TERIST ICS
Address Input Current,
Input Voltage High, IAH VA = 2.4V -10 -0.002 - -10 -0.002 - μA
VA = 15V - 0.006 10 - 0.006 10 μA
Address Input Current Input
Voltage Low, IAL VEN = 2.4V VA = 0V -10 -0.002 - -10 -0.002 - μA
VEN = 0V -10 -0.002 - -10 -0.0002 - μA
ANALOG SWITCH CHARACTERISTICS
Analog Signal Range,
VANALOG (Note 7) -15 - +15 -15 - +15 V
Drain-Source ON
Resistance, rDS(ON) Sequence Each
Switch ON
VAL = 0.8V,
VAH = 2.4V
IS = -200μA, VD = +10V - 270 400 - 270 450 Ω
IS = -200μA, VD = -10V - 230 400 - 230 450 Ω
rDS(ON) Matching
Between Channels -10V ≤ VS ≤ +10V - 6 - - 6 - %
ΔrDS ON()
rDS(ON)MAX rDS ON()MIN
–
rDS ON()AVG
-----------------------------------------------------------------------
=
DG508A