SCOPE: PRECI SION REFERENCE +5 VOL T ADJ USTABLE OUTPUT
Device Type Generic Number
03 REF02A(x)/883B
04 REF02(x)/883B
Case Outline(s). The case outlines shall be designated in Mil-Std-1835 and as follows:
Outline Letter Mil-Std-1835 Case Outline Package Code
MAXIM SMD
Z P GDIP1-T8 or CDIP2-T8 8 LEAD CERDIP J8
J G MACY1-X8 8 LEAD CAN G99
RC 2 CQCC1-N20 20 PIN LCC L20
Absolute Maximum Rati n gs
Supply Voltage VDD to GND .................................................................................. 40V
Output Short Circuit Duration (to GND or VIN) .............................................. Indefinite
Lead Temperature (soldering, 10 seconds) .............................................................. +300°C
Storage Temperature ................................................................................. -65°C to +150°C
Continuous Po wer Dissipation .............................................................................TA=+70°C
8 lead CERDIP(derate 8.0mW/°C above +70°C) .................................................... 640mW
8 pin CAN (derate 6.67mW/°C above +70°C)......................................................... 533mW
20 Pin LCC (derate 9.09mW/°C above +70°C)........................................................ 727mW
Junct ion Temperature TJ ....................................................................................... +150°C
Thermal Resistance, Junction to Case, ΘJC:
Case Outline 8 lead CERDIP................................................................... 55°C/W
Case Outline 8 lead CAN ........................................................................ 45°C/W
Case Outline 20 Pin LCC ........................................................................ 20°C/W
Thermal Resistance, Junction to Ambient, ΘJA:
Case Outline 8 lead CERDIP................................................................. 125°C/W
Case Outline 8 lead CAN ...................................................................... 150°C/W
Case Outline 20 Pin LCC ...................................................................... 110°C/W
Recommended Operating Conditions.
VOUT @ 25°C for device 03 ............................................................................ 5V ±15mV
VOUT @ 25°C for device 04 ............................................................................ 5V ±25mV
Ambient Operating Range (TA) ........................................................... -55°C to +125°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device.
These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
---------------------------- Electrical Characteristics of REF02 & 02A/883B 19-0346 Rev. C
for SMD 85514 Page 2 of 6
TABLE 1 ELECTRICAL TESTS
TEST Symbol CONDITIONS
-55 °C ≤TA≤ +125°C
VDD=+15V, VIN=+15V
Unless otherwise specified
Group A
Subgroup Device
type Limits
Min Limits
Max Units
Quiescent Supply
Current IIN No load 1
2,3 All 1.4
2.0 mA
Output Adjustment
Range ∆VTRIM RP=10kΩ1 All -3.0 +3.0 %
Output Voltage VOIL=0mA 1
2,3 03 4.985
4.978 5.015
5.022 V
Output Voltage VOIL=0mA 1
2,3 04 4.975
4.953 5.025
5.047 V
Short Circuit
Current ISC VO=0 1 All +15 +60 mA
Sink Current IS1All-0.3 mA
Load Regulation
NOTE 1 LD re g IL=0 to 10mA
IL=0 to 8mA
1
2,3
All
03
04
0.010
0.012
0.015
%/mA
Line Regulatio n
NOTE 1 LN reg VIN=8V to 33V 1
2,3
03
04
All
0.010
0.012
0.015 %/V
Load Current ILNOTE 2 1 All 10 mA
Output Voltage
Noise enp-p 0.1Hz to 10Hz 4 All 100 µVp-p
Output Voltage
Temperature
Coefficient TCVo NOTE 3 7,,8 03
04
±8.5
±25 ppm/°
C
NOTE 1: Line and Load Regulation specifications include the effect of self-heating.
NOTE 2: Minimum of 10mA load current guaranteed by load regulation test.
NOTE 3: VMAX-VMIN (-55°C to +125°C)1x106
TCVO= ----------------- x ----------------------------------
5V +180°C
---------------------------- Electrical Characteristics of REF02 & 02A/883B 19-0346 Rev. C
for SMD 85514 Page 3 of 6
PIN CONFIGURATIONS
8 Lead CERDIP 8 Lead CAN 20 Pin LCC 20 Pin LCC
1NC NCNC11NC
2V
IN VIN NC 12 TRIM
3 TEMP TEMP NC 13 NC
4 GND GND (case) NC 14 NC
5 TRIM TRIM VIN 15 VOUT
6V
OUT VOUT NC 16 NC
7NC NC TEMP 17NC
8NC NCNC18NC
9NC19NC
10 GND 20 NC
ORDERING INFORMATION:
Device Package Maxim Device SMD Number
03 G99 REF02AJ/883B 8551403GC
03 J8 REF02AZ/883B 8551403PA
04 G99 REF02J/883B 8551404GC
04 J8 REF02Z/883B 8551404PA
04 L20 REF02RC/883B 85514042C
---------------------------- Electrical Characteristics of REF02 & 02A/883B 19-0346 Rev. C
for SMD 85514 Page 4 of 6
QUALITY ASSURAN CE
Sampling and inspection procedures shall be in accordance with MIL-Prf-38535, Appendix A as specified in Mil-Std-
883.
Screening shall be in accordance with Method 5004 of Mil-Std-883. Burn-in test Method 1015:
1. Test Condition, A, B, C, or D.
2. TA = +125°C mini mum.
3. Interim and final electrical test requirements shall be specified in Table 2.
Quality conformance inspection shall be in accordance with Method 5005 of Mil-Std-883, including Groups A, B, C,
and D inspection.
Group A inspection:
1. Tests as specified in Table 2.
2. Selected subgroups in Table 1, Method 5005 of Mil-Std-883 shall be omitted.
Group C and D inspections:
a. End-point electrical parameters shall be specified in Table 1.
b. Steady-state life test, Method 1005 of Mil-Std-883:
1. Test condition A, B, C, D.
2. TA = +125°C, minimum.
3. Test duration, 1000 hours, except as permitted by Method 1005 of Mil-Std-883.
TABLE 2. ELECTRICAL TEST REQUIREMENTS
Mil-Std-883 Test Requirements Subgroups
per Method 5005, Table 1
Interim Electric Parameters
Method 5004 1
Final Electrical Parameters
Method 5005 1*, 2, 3, 4
Group A Test Requirements
Method 5005 1, 2, 3, 4, 7, 8
Group C and D End-Point Electrical Parameters
Method 5005 1, 2*, 3*
* PDA applies to Subgroup 1 only.
** Guaranteed if not tested.
---------------------------- Electrical Characteristics of REF02 & 02A/883B 19-0346 Rev. C
for SMD 85514 Page 5 of 6
